5/8 Inch Wind Turbine Shaft Arbor Adapter for 17 mm Blade Hubs

Description

Free shipping to the lower US 48 states only,
excluding PR, Hawaii, Alaska
THE ORIGINAL BY MISSOURI WIND AND SOLAR
THIS HUB ADAPTER WILL
CONVERT YOUR 5/8" MOTOR SHAFT TO
FIT ANY HUB WITH A 17MM CENTER HOLE
CLICK HERE TO SEE ALL OF OUR HUB ADAPTERS
MADE FROM HIGH QUALITY STEEL WITH A HIGH TENSILE STRENGTH (NOT CHEAP ALUMINUM)
17MM  25TPI FINE THREAD (NOT 1/2'' COARSE THREAD THAT WILL LOOSEN)
5/16'' ALLEN SET SCREWS FOR REAL TORQUE (NOT TINY SET SCREWS THAT CAN'T BE TIGHTENED)
OURS ARE GOLD ZINC PLATED, WON'T RUST! (ALUMINUM WILL OXIDIZE AND SEIZE TO A STEEL SHAFT)
DESIGNED BY A MILITARY CONTRACTOR
WILL LAST A LIFETIME, AS HEAVY DUTY AS YOU CAN GET
(LIFETIME WARRANTY)
MADE IN THE
U
S
A
DO NOT TRY TO SAVE MONEY ON A HUB OR HUB ADAPTER,
THE FAILURE OF EITHER CAN BE DEADLY!
NOW YOU CAN USE A HUB WITH A 17MM HOLE CENTER FOR YOUR 5/8'' MOTOR SHAFT
VERY FINE THREAD ON OUR 17MM SHAFT, NUT WILL NOT LOOSEN AND COME OFF LIKE COARSE THREAD WILL.
OUR HUB ADAPTER WILL FIT RAPTOR HUBS, HORNET HUBS, WIND SCORPION HUBS AND ALL HUBS WITH 17MM CENTER HOLE. NOW YOU CAN USE REAL TURBINE BLADES AND HUBS!
CLICK HERE TO SEE OUR FULL LINE OF WIND AND SOLAR PRODUCTS!
We do not mark items as gifts or under report values for customs. For International buyers,
it is strongly recommended to check your own country's tax practices as we do not
pay your taxes, duty or customs fees.
We do not over charge for shipping; it is simply what the shipping calculator comes up with.
Customs fees or taxes are not included in shipping, it is your responsibility to pay them.
UPS orders shipped signature required at our discretion!! Contact us right away if you need to make other arrangements!
Products may be slightly different than the ones pictured. If our supplier runs short of the products shown, we will substitute them for the same quality or better.